Star Tech Journal

More than likely it needs to be adjusted (refer to
Figure 1). If the belt is clicking, it's probably too
loose. Loosen the two screws shown in Figure 1
and adjust belt to a finger tension of 3/32" play.
If this doesn't work, the big white gear or Reduc-
tion Gear may be broken.
3/ 32 Inch Total Fiexlng
Permlssable At This Point
Motor Mounting
Assembly
MAGNETIC HEAD PROBLEMS
This is usually indicated by the BT rejecting a
fairly good shaped 1985 series bill (refer to Rowe
Service Bulletins G-102 and G-107). OBA-2Con-
trol Units don't tell you if the Magnetic head is
the cause of your bill acceptance problems, but
the new OBA Control Units (610389-03), the
ones with Rowelink Communication, flashes the
fault light 5 or 6 times after rejecting a bill, to
indicate problems associated with the Magnetic
Head.
Figure 2: Drive Belt Tension Adjust
Idler Pulley
3/16 Inch
Total Flexing
Permissible
At This Point
Adjusting Screws ~-+-~~l
(2 on each side)
Figure 7: Lower Belt Tension Adjust
continued on next page ...