Star Tech Journal

em
STAR*TECH Journal
August 1993
... continued from page 78.
STEP 17.
Remove shoulder screw from
the base on dino which is hold-
ing the crank arm to the as-
sembly. This screw uses a flat
tip screwdriver. (See Figure
6).
Figure 7
STEP
figure 6
19.
Attach new crank arm making
sure the open portion of the
crank arm clears the left/right
motor assembly. Re-attach the
shoulder screw to the base of
the dinosaur assembly after
threading it through the crank
arm.
NOTES
Attach the spring between the
motor cam stud groove and the
crank arm bottom hole. (See
Figure 7).
STEP
18.
Pull crank arm off and discard.
STEP
21.
22.
We have also added 2
springs for the flipper assem-
bly. These springs are just to
have on hand in case failure
occurs.
b)
Detach the spring on the dino
ball eject crank arm and in-
stall new one. (See Figure 8).
STEP
STEP
2 extra diodes have been
supplied in the kit for a n r
problems with the center
scoop switch.
a)
Spring
20.
Attach the crank arm and new
washers onto the motor cam
stud. 1/16" thick washer first,
then the crank arm, then 11/
32" washer.
Figure 8