July 1996
1)
CID
2)
HOPPER DISPENSING AsSIGNMENTS
TY-40 Hopper A
TY-40 Hopper B
TN-20 Hopper A
TN-20 Hopper B
5D-10 Hopper A
5D-10 Hopper B
QT-00 Hopper A B C D
1 C-02 Hopper A
1 C-02 Hopper B
When programming is complete,
press "exit" on the key pad. Shut
off the power and proceed to step
four.
. ccs
f
:m
f
- I
~
--
I f
_,.....
HOPPER VALUES
VA=025
VB=025
VC=0000
VD=0000
3) AccuMuLATEIV ALUE
To get to this function push
Accumulate then Value
ACV=O000
unit to see if it functions properly.
Now insert the calibration paper
and do your regular calibration
procedure as instructed in the
I!!!!!! !I
0 ODD
lla:N!!!f
oa
~o-•
D
•-1 c:
~o-s
NAf
Is·
.
o-
. .
,-,~ -· ...
!el o""
~
D
o o 1 .,.,.,
STAR*TEcH
position. Starting with pot 1, ei-
ther left hand (orange) light, or
the right hand (green) light will
come on. If the left hand light is
on, tum pot 1 clockwise slowly
until the light goes off. Wait a few
seconds and both lights will come
on, indicating that you have
proper adjustment of the pot.
Conversely, if the right hand light
comes on, tum the adjustment
pot counter-clockwise until the
light goes off. After you have
made your adjustments and both
lights have come on, wait until
they again go off, indicating that
you may proceed to the next ad-
justment pot. Proceed to the pot
2 and follow the same proce-
dures. Your unit will automati-
cally advance through all 5 posi-
tions. After the last adjustment is
made, a few seconds will pass and
the card will be rejected. Your
unit is now properly calibrated
and will accept all of the currency
your unit has been programmed
for. Now tum off the power and
replace the side cover. End of
procedure.
Figure 2
Turn power on and
see if any errors appear in the dis-
play, (If errors occur see your
manual). If not, our first proce-
dure will be to calibrate the bill
verifier. Shut the power off and
before turning the power back on
again, adjust pot 2 (using a small
flat head screw driver) com-
pletely counter-clockwise then 1/
4 turn clockwise (see figure 2 for
pot location). Power up the C-500
STEP FouR:
manual (see step five if manual
is not present). After the calibra-
tion period, your conversion
should be complete and operat-
ing properly as it was before, only
now you have Loonie and Toonie
capabilities. Good Luck!
With power on, insert
calibration card with the arrow
up. The card will be accepted by
the unit and stop in the proper
Journal
STEP FIVE:
Figure 3