Willianis Bride of
Pinbot Relay Board
Kingsley Sime
K. Sime Machines
Lancashire, England
Dynanio HS-4
Cabinet Precaution
Todd Erickson
Summit Amusement
St. Paul, Minnesota
SUBJECT
SUBJECT
We have had problems with one machine not
lining the correct face up and struggled with all
the usual remedies with no success. We tested
the microswitches, diodes, wires off. All to no
avail.
The Dynamo HS-4 cabinet has been a real asset
to the business of kit games. It's been my expe-
rience that games will earn more in this over-
sized cabinet. And since I've purchased a 4-
player control panel from Dynamo, this cabinet
will be the game housing for the 1990's.
SOLUTION
After many hours we tracked • it down. Other
operators beware! Under the playfield there is a
small relay board described in the manual as a
lamp PCB.
PRECAUTION
This cabinet does have one major flaw. however.
On early models, if you drop the marquee down
the back while installing the game, it would snap
off the back of the CRT.
This is most definitely not a lamp relay, it con-
trols the head movement clockwise and
anticlockwiseThis is where we had a bad solder
on the relay terminal.
Not only will you have to buy a new tube, or
possibly an entire monitor, but you could very
easily harm your employee.
NOTE
SOLUTION
Save yourselves some time and mark your
manuals accordingly!
Needless to say, I feel some sort of protection
should be provided for this potentially danger-
ous area at the neck of the picture tube.
Matsushita Monitor
Bright Raster
Rowe AMI
Mechanisni Control
Randy Terry
Alpine Amusement
Connersville, Indiana
Randy Terry
Alpine Amusement
Connersville, Indiana
PROBLEM
SYMPTOM
Matsushita monitor #TM-202 G has picture
that's too bright with horizontal retrace lines.
AMI juke boxes using mechanism control board
(4-07221-02) continuously scan. Optical switch
and wiring to optical switch known good.
SYMPTOM
B+ (180vdc) low(@ 125vdc).
SOLUTION
Replace Z202 (RC 3302OB).
SOLUTION
Replace cap C559 (4. 7u 250v), it's open.