• STAR*TECH Journal
ThE PINBALLS INVOLVED ARE:
~~~§~~ttle; ~rcerer, Comet, Strike1ne, High
Speed, Grand lizard, Road Kings, Alley Cats,
Pifibofand Millionaire.
• • • •
)
NoTE 1
If you have a bad coil, you can just replace it with
a parallel coil. For Williams use #FL-11630 and
for Data East use #090-5013-00. And wire as
shown in Figure 3.
...........
bXr-6.t:Asr
~~,.. Wars
2
If you replace one with a parallel coil, replace the
other one at the same time or it will cause a
power imbalance.
NOTE
and · Secret Service.
If you have any of these pinballs, check for series
coils. In Williams the coil number is 04-0933 or
FL-23-600/30-2600, and in Data East the num-
ber is 090-5012-00 or 23-600/30-2600. If the
coil is already a parallel coil check to see if it is
wired correctly (See Figure 3).
PARTS NEEDED
• Two (1 for each coil) 1N4003, or ECG 116 diode
• Two (1 for each coil) 2.2 mfd 250 volt non-
polarized capacitor if needed.
PROCEDURE
>JUST DO IT!
Do~'t Let Those Time & Money Saving
• Mod's, Fixes & Technical Tips
Gather Dustln Your Service Files ...
• Mail or fax themto STAR*TECH Journal & keep your
name (and your company's) out in front with the most
progressive technicians in the Coin-op Industry. Share the
· knowledge!
STARifTECH Journal,, PO Box 1065,
18 Norlh Centre Street, Merchantville, NJ 08109
Phone: 609/662-1080 0 Fax: 609/662-0537
1. Remove flipper coil from pinball (don't worry
about wire order).
2. Add diode across lugs 2 & 3. See Figure 1 (note
diode direction).
3. Replace coil in pinball.
4. Solder positive lead from backbox to lug 2. See
Figure 1.
5. Solder negative lead from cabinet flipper
switch to lug 1. See Figure 1.
6. Solder leads from EOS switch to lug 1 and lug
3. See Figure 1.
•
•
•
•
Practically eliminates table-side injuries!
Practically eliminates costly property damage!
Doesn't affect table play.
Installs in 15 minutes with only a screw driver.
*** ALSO AVAILABLE FOR U.S. BILLIARDS! ***
7. Add capacitor across EOS switch, if no capaci-
tor is present.
8. Clean the contacts while you are there.
9. Tie the capacitor down with wire tie.
Increases Player Appeal! Arcade Tested!
1000's IN USE
In 5 Countries on Three Continents
Made From Virtually
INDESTRUCTIBLE SPACE-AGE MATERIAL!
LIFETIME REPLACEMENT GUARANTEE
ACCEPT NO SUBSTITUTES!
10. Put silicone at each end of capacitor. To keep
the leads from breaking at capacitor. Figure 2.
ORDER TODAY!
800/933-0145