August 1987 (16)
STAR*TECH Journal
Lightly oil the areas marked A.
Apply a thin coat of grease to the
areas marked B.
BEFORE
SIDE VIEW
AFTER
f'l&ure 3. Lamp Resistor Board CoMectlon Chups
3. A precaution to prevent binding of the
diverter gate asserrbly. '!he necessary
parts to canplete this can be obtained
from your authorized Williams
Distributor. The two part mmbers are
03-8042 (plastic washer) and 20-8712-18
CE-ring clip) .
a. 'Ibis procedure puts more pllD'lger
length inside the diverter coil in
the "rest" position. Locate Tab c.
Bend the tab inward with pliers,
pressing the Diverter Gate, E,
toward the right side of the game.
Bend Tab C until the gate is flush
with the gate "port" in the plastic
trough.
b. Locate Anti-magnetic PllD'lger Stop
o. Bend the plunger stop forward
until Gate Fis flush with the gate
"port", and does not interfere with
ball travel in the plastic trough.
Use of preventive maintenance to
prevent binding is recamended.
Clean off areas A and B to prepare
these surfaces for lubrication.
c ~ '!he next procedure prevents
magnetic binding of the Diverter
Gate Asserrbly. Reoove E-ring, N.
Reroove Pin J from the pllD'lger
pivot asserrbly. Replace steel
Washer L with the Plastic Washer.
Reasserrble the plunger pivot
assenbly by pushing Pin J up
through the Bell Crank K, plastic
Washer L, PllD'lger M, and secure the
asserrbly by reattaching the E-ring
N.
SANPLE COPIES of STAR*TECH JOURNAL for
your next State Association meeting era
available. Just sand us your requirements
such as: Data needed, quantity, mailing
address and to wham's attention. Sand
requests to: STAR*TECH JOURNAL, PO Box
1085, Merchantville, NJ 08109.
~