Star Tech Journal

Issue: 1985-October - Vol 7 Issue 5

STAR*TECH Journal
•••••••••••••••••••••••••••••••••••••••••••••••••••••
DATA EAST
CASSETTE SYSTEM:
Operation & Maintenance
One of the most important components
of this system is the Cassette deck, as
it transfers the actual game program
data from the tape to the logic boards,
Consequently, regular maintenance to
the cassette deck is advisable to
ensure a long trouble free life,
THEORY OF OPERATION
Three leaf switches detect the
presence and correct orientation of the
tape, When the tape is inserted
correctly, the tape is rewound at high
speed to the beginning of the tape,
where the BOT/EQT sensor detects the
clear header tape, The tape is then
wound forward at a constant speed for
data to be read.
As the data is stored on the tape in
sections, the cassette deck reads the
tape in sections and stops the tape to
verify the data. If the data is
correct, the deck will then read the
next sect ion,
If the data is faulty or read
incorrectly, the deck will rewind to
the beginning of that section and
attempt to read it again. If it fails
seven times in re-reading a section of
data, the machine will reset and
display a cassette error message.
When the tape has been fully read,
the tape is rewound to the beginning of
the tape, ready for the next data
transfer,
GENERAL FAULTS
Data may be corrupted from a data
tape in one of several ways:
1. TAPE HEAD FAULT. The tape head
must be clean and correctly positioned.
2. DRIVE MECHANISM FAULT. Data must
read at correct speed otherwise data is
not accepted by the logic boards.
3. P.C.B. FAULT. Tape head amplifier
or motor drive electronics may be
faulty causing too small a signal or
corruption of data.
4. TAPE FAULT. The data on the tape
■ay be corrupted due to exposure to
strong magnetic fields, inadequate
handling or storage, or misuse. Solle
tapes may be too tightly wound and so
cause the motor to operate slOMer,
causing the data to be r-eJected.
GENERAL MAINTENANCE
Once every month or two, clean the
tape head with a cotton swab soaked in
denatured alcohol. Once every 12 to 15
110nths, the deck should have the rubber
drive wheels replaced, the speed
calibrated, and the tape head adJusted,
This is preventive maintenance that
can be done by Data East should you not
have the necessary test equipment.
This service is NOT covered under your
lifetime warranty~
CASSETTE ERROR CODE INFORMATION
Error Code
Solution
01
1,8,9,3
82
3,4,5,
3,4,5
3,4,5
2,3
83
04
32
33
5
8,9,4
52
58
3,4,5
6,7,8
59
SOLUTIONS
1. Check the tape and module game
ntllle to ensure they are properly
matched,
2. Clean the tape deck head with
alcohol and cotton swab.
3. Change the cassette tape,
4, Change the cassette deck,
5. If error persists, change the BIO
board.
6. Check the tape deck connector.
7. Check the key module connector.
8, Check the tape to ensure side 'A'
is facing up,
9. Check the tape to ensure that the
tape is on the spool opposite the
letter 'A', if not, advance the tape
manually onto the correct spool with a
screwdriver.
~
RO □ T·
TI-E PLAYER
By John 'Root' Pilarchik
Pennsauken, NJ
A 110nthly analysis of pinball
machines cuurently out on the street
from strictly a player's point of view.
EIGHT BALL DELUXE by Bally has to be
one of the best machines to come along
in recent years, First to be introduced
was the original EIGHT BALL which was a
sharp machine. Next came the EIGHT BALL
DRUXE Model which, in my opinion, out
classes Just about every machine that I
October
l'385
(4)
have played to date.
Flipper skill, not luck, is the key
to succeed in hitting on this machine.
I myself usually favor a machine which
features the standard two flippers,
hONever, EIGHT BALL DELUXE has a third
flipper located on the far left side at
the midway point of the machine
(directly across from the Deluxe
targets), which can benefit the player
who possesses the proper flipper
skills, By using the appropriate
strategy and shooting the ball up the
left side, you can work your way up to
the Free Ball and then onto the
Special,
Next, the left side features the Bank
Shot where you can work your way up
from 5,000 points and also a Special.
The key characteristic of this machine
is the Deluxe targets located on the
right side, By knocking down all the
targets twice and hitting the Eight
Ball, you will succeed in obtaining
another game in addition to lighting up
another letter on the back glass t01o1ard
spelling the word 'DRUXE', which, once
accomplished, will award you three Free
Salles. This feature keeps the players
endeavoring to spell out D-E-L-U-X-E
which means that the machine gets
plenty of playing time. These letters
on the back glass remain lit game after
gtllle until the full word 'DaUXE' is
spelled out and then this process is
repeated.
Example:
A player has been at the machine for
a period of time and has accomplished
the letters 'DELUX' before retiring.
Another player comes along and has only
the remaining letter 'E' to succeed in
receiving three Free Games. This player
will attempt to gain this last letter,
spending however much time he feels
necessary in trying to obtain this
goal; and so the cycle goes,,,
Of all the games that have passed
through the local establishments, this
particular machine appears to be the
finest and busiest of all, There was a
time when you could find this machine
almost everywhere, but now it's getting
10re difficult to-find this machine to
play. To me, it seems a waste to allow
a sharp machine like this to pass
through the doors.
Another machine of Baily's that
offers similar fun and reward is
FRONTIER. A fine characteristic of this
11achine is the variety of ways to hit
on Specials which keeps the true
players interest and also, bonus points
accumulated remain through the entire
game,
Although, as I stated before (see
last month -S*TJ Vo17, No4), I
preferred a three game interval of
scores for hitting games, this machine
··························································································-············
STAR*TECH Jc,ur·n a 1 •••••••••••••••••••••••••••• .. •••••••••••••••••••••• ******
only offers two. But with its many
Specials offered, it more than
compensates for this.
I found that while in a particular
hangout of mine, the regulars seemed to
en.ioy competing against one another for
drinks, where low scorer pays. This
results in money being pumped into the
machine, as well as across the bar.
What more could both sides ask for?
A Final Note:
To the genuine player there isn't
anything more frustrating than playing
a machine in which the flippers lack
power. I believe that the flippers on
the machine can make or break a machine
and, therefore, should be maintained on
a regular basis to ensure that the
rubber and power of same are kept in
tip-top shape! Play on ... ROOT.
Score(sl can also gain a replay reward.
Williams designs all System-9 games
COMET, to new a few) to include many
operator-adJustable settings for the
game features, thereby permitting a
wide range of challenges and rewards
for the player. This allows the
operator to vary the setting of many
features to contend with whatever level
of player skill the operator finds at
each location, In addition, it even
allows the operator the ability to
evaluate the number of replays obtained
by exceeding the high score(sl, as well
as how many times other features were
exceeded. In this way, Williams allows
the operator to adJust the game to suit
the location, so that he can achieve a
consistently good earning level for the
SYSTEM 9 GAMES
Williams appreciates the C0111111ents
provided by John Pilarchik in his
September '85 "ROOT /PLAYER" column
about the SPACE Sl-llTTLE game. lln
addition to the game registration cards
returned by our operators, Williams
utilizes this information as part of
our "user feedback" (also provided by
our test game locations, as well as
in-house testing, and other user
communcationsl. "User feedback" aids
our gaae designers in establishing the
Factory Settings of various game
features, improving game operation,
etc.
As a long-time pinball player, Mr.
Pilarchik's C0111111ents reflect a player's
point-of-view about SPACE SHUTTLE, a
pinball game that has been very
successful and profitable in a variety
of locations for many operators. He
does remark about what may be a
significant item requiring
clarification to the game operator:
Factory Settings (such as 1,200,000
points) are ONLY recomendations. The
operator can raise or lower these
settings, by simple switch operation,
as described in each game's Instruction
Manual, to allow whatever level of
player reward he desires. (For example,
the operator could adJust this game to
enable the player to have as many as
four replay levels,) Exceeding High
< 5)
NEWB---
Sega Enterprises, San Jose, CA, is
now accepting printed circuit boards
for repair. The Customer Service group
is handling all Sega (not Sega/Gremlinl
games such as; HANG ON, NINJA, PITFALL
II, MY HERO, etc ...
Data East has a limited number of
titles left for the DECO Cassette
System. These are available through
your authorized Data East distributor,
Please have them check with Data East
for the new lower price, as it is a
deal! The games currently available
include: PRO GOLF, PRO BOWLING, PRO
TENNIS, PRO SOCCER, i'IISSION X, ASTRO
FANTASIA, LOCK AND CHASE, SUPER ASTRO
FIGHTER, CLUSTER BUSTER, BUMP N' JUMP,
and BURGERTil'IE ...
game.
The Williams' Factory Settings are
only intended as initial guidelines to
the operator, Reference to the
Instruction Manual's Bame AdJustment
Procedure shows the adJustable features
and their setting ranges (enabling the
operator to control the number of
rewards given to the player),
WILLIAMS
October 1 '385
Reference to the Instruction Manual's
Bookkeeping "1ode allows the operator to
check h01r1 many times each gaae's player
rewards are achieved; the operator can
then determine whether a feature needs
a change in setting, When it does, a
few operations of the switches on the
Coin Door (and perhaps the Credit
button) are all that are necessary to
achieve the desired change,
Thus, Williams provides each operator
with the opportunity to be a "Bame Play
Designer", by the settings he provides
in each game. He certainly becomes his
own Profit Designer via these settings;
his choices determine the level of
replays given as rewards to the
skillful player, and they obviously
affect the income the operator receives
fro111 the game. Williams hopes that each
operator is utilizing these adJustments
to the fullest, giving the player the
proper challenge (and Reward), while
keeping the game's earnings at the
proper level, Good Reward/Bame Play=
Excellent Profits!
NEWS2---
SHOWS:
AMOA Expo '85 is to be held Oct.
31-Nov. 2 at the Chicago Hyatt Regency,
For more info Tel: 312/644-6610, This
exposition of games and music machines
is the grandaddy of North American
Shows •••
JA191A (Japan Amusement Machinery
Manufacturers Association) held its
23rd Annual show Oct. 2-3 at the Tokyo
Ryutsu Center. JAMMA will hold its 24th
show at the same location on Oct. 8-9,
1986. For more info Tel: 03-593-2563,
Many new Industry trends are uncovered
here ...
CIC (China International Convention
Service) will hold the Amusement Expo
'86, an International Recreational and
Educational Technology Exposition at
BeiJing, the PRC, during the week of
March 28 - April 3 1 1986. For more info
Tel: (Hong Kong) 3-7217689, ..
NEW PRODUCTS:
Jensen Tools, Inc., has recently
introduced a lightweight (1.25 lbs),
compact (8, 25"x4. 5"xl, 75" l and powerful
(10 MHz) portable LogicScope for
digital field service. For more info or
free catalog Tel: 602/968-6231 ...
Electronic Specialist Inc., has
released their newest Hi-Tech Equipment
Protection & Interference Control
Catalog. For more info Tel:
617 /655-1532 ...
* * •• * •••• fi * ••• *. **** * *-*.**. !' ••••••• * * *·* "'!** * *!' ** * !' •••••••••••• ** ••••• *-*-* *• •• * * ***** •·• *. * ................... .

Download Page 4: PDF File | Image

Download Page 5 PDF File | Image

Future scanning projects are planned by the International Arcade Museum Library (IAML).

Pro Tip: You can flip pages on the issue easily by using the left and right arrow keys on your keyboard.