10
STAR* TECH JOU ANAL/FEBRUARY 1984
BALLY MIDWAY
SERVICE BULLETINS: NFL FOOTBALL:* CREDIT AND SELF-TEST SWITCH * BREAK-IN PERIOD AND DISC CLEANING
* RCA VIDEODISC PLAYER SHUT DOWN PROCEDURE * DIP SWITCHES
* RCA DISC PLAYER OPERATION PROCEDURE* RCA DISC PLAYER - SHIPPING TABS* RCA VIDEO DISC SKIPPING
SPY HUNTER:* POWER CHASSIS MODIFICATION* UPRIGHT & SIT DOWN LOGIC BOARD INTERCHANGEABILITY
* UPRIGHT & SIT DOWN SOUND IN ATTRACT MODE OPTION
ASTRON BELT: * VIDEODISC PLAYER COVER
NFL FOOTBALL CREDIT AND
SELF-TEST SWITCH
1. The red credit button and self-test switch
will not be used presently.
2. The ROM RAM and switch test is not
available.
3. The self-test switch must be in the UP
position for proper coin credits.
DISC BREAK-IN PERIOD
A certain amount of skipping may be noticed in
the first hours of use. This is normal and will
not affect the play of the game. As the game is
played, this condition will subside.
DISC CLEANING INSTRUCTIONS
Your new CED VideoDisc and VideoDisc
Player may require periodic cleaning. This is
evident when excessive skipping is observed
after the initial break-in period. The following
instructions will help in minimizing this
condition.
1. Unloading and reloading the disc into the
videodisc player cleans both the disc and
stylus in the player. In most cases this will
correct the problem.
2. If the above does not correct the excessive
skipping, you may flip the disc over. The
same material has been encoded onto both
sides of the videodisc.
1. Tum main power off.
2. Disconnect J3 from the IPU Board. (This
unleashes the player from the logic.)
3. Tum main power on.
4. Press "Reject" - located on front label of
player.
5. Insert disc cover when display reads" UL" -
indicating unload.
6. After disc has been removed, tum power
switch off(located on front panel of player)
and wait momentarily until door closes.
7. Tum main power off.
8. Replace J3 on IPU Board
The player should NOT be allowed to sit idle
with the door open for long periods of time.
RCA VIDEODISC PLAYER
SHUT DOWN PROCEDURE
After removing the disc from the RCA
VideoDisc Player, the disc door must be closed.
The following sequence will close the disc door
and prevent dust contamination.
DIP SWITCHES (SWITCH NO. 1 AT 83) NFL OPTION SWITCH SETTINGS
SWITCH NO. 1 - AT B3 - LOCATED ON SOUND 1/0 PC BOARD
GAME PLAY:
**2
3
4
5
MINUTE
MINUTE
MINUTE
MINUTE
GAME
GAME
GAME
GAME
SW#1
SW#2
ON
OFF
ON
OFF
ON
ON
OFF
OFF
**50¢ GAME
25¢ GAME
SW#3
SW#4
SW#5
SW#6
SW#7
SW#8
SW#9
NOT
USED
NOT
USED
NOT
USED
NOT
USED
SW#10
ON
OFF
ATTRACTION SOUNDS OFF
**ATTRACTION SOUNDS ON
ON
OFF
**DISPLAY (TIME) OFF
DISPLAY (TIME) ON
ON
OFF
ON
OFF
FREEZE VIDEO
**NORMAL OPERATION
SWITCH NO. 3 - AT D14 - LOCATED ON SOUND 1/0 PC BOARD IS NOT USED
PART NO. M051·00A34-A007
**FACTORY RECOMMENDED SETTINGS.
9. Don't attempt to open disc sleeve. Don't
transport Player with disc inside.
RCA DISC PLAYER OPERATION
1. TIIE VIDEODISC COMES IN A SLEEVE
WHICH IS MOUNTED ON TOP OF
TIIE PLAYER LOOSEN TWO (2) WING
NUTS TO REMOVE IT.
2. Push Power Button to tum Player "On."
The indicator will flash on the Player's
Digital Display.
3. Insert notched edge of disc sleeve into
Player slot at a slight angle as illustrated.
NOTE: Insert Side One when game is new.
(See Videodisc Skipping Bulletin.)
RCA DISC PLAYER- SHIPPING TABS
Push the disc sleeve forward until you feel
the Player mechanism pull the disc sleeve
into the slot. The Player automatically loads
the disc and returns the empty sleeve.
4. Remove the sleeve from the Player to start
disc play.
5. DO NOT DISCARD SLEEVE! DISC
CANNOT BE REMOVED WITHOUT
IT.
6. TO REMOVE DISC, TURN POWER
OFF. REMOVE JACK J3 ON I.P.U.
CARD. TURN POWER ON. PRESS
" REJECT". DISC WILL RETURN TO
THE UNLOAD POSITION.
7. To remove the disc from the Player, refer to
steps 3 and 4.
8. TO USE OPPOSITE SIDE OF DISC OR
NEW DISC - REINSERT DISC AS IN
STEPS 3 AND 4. TURN POWER OFF.
PLUG IN J3. TURN POWER ON. GAME
WILL OPERATE NORMALLY.
CAUTION: Shipping Tabs must be removed
from the VideoDisc Player before you operate
the unit Locate the Shipping Tabs by referring
to the drawing below.
Rotate Tabs in the direction of the
arrow until the rounded edge is
facing toward the front of the Player.
Pull down on the Shipping Tabs and
remove them from the Player.
SAVE THE SHIPPING TABS - THEY
MUST BE REINSTALLED WHENEVER
THE PLAYER IS TRANSPORTED.
1
2
.
'
2
',
Continued on next page.