Coin Slot Magazine - #042 - 1978 - July [International Arcade Museum]
long screws upward until desired tension in attained. To speed up
reels, use the reverse procedure. Do not allow reels to spin to fast
since this causes excessive bouncing and vibration.
7.
Never use a sharp instrument to dislodge coins in excalator.
Use toothpick or blunt scraping wire. Do not bend the coin "buter-
fly" since this will cause coins to stick or return.
8.
Upon collection, remove all mutilated coins and turn them in
to your bank. When loading tubes avoid use of new coins.
9.
When replacing mechanism in cabinet be certain that the latches
on both sides hold mechanism fast to cabinet.
10.
Mechanism should never be switched from one cabinet to
another.
11.
Do not allow players to shake machine. The chief mechanism
is precision buit and should be treated accordingly.
12.
Keep or record you Key Numbers and additional set of keys can
be supplied by the factory by giving them the key number.
13.
Do not load payout tubes with too many coins at a time. Allow
them to drop in slowly and settle horizontally to prevent jamming.
14.
Should handle return to starting position too fast, release nut on
pump to left of coin box, run the bolt in a few turns, then tighten
nut.
If handle returns to starting position too slowly, turn bolt out
a few turns and tighten the nut.
15.
Failure to pay out-remove mechanism from cabinet, turn on
.com
m
:
u
sure spring on vertical payout
rom lever
u is se not disconnected, broken or
m
-
ed f of a vertical
e
scratched. Check a finger
payout lever to make sure it does
d
d
o
l
c
r
n
a
.
w
not bind against
Do //w sides
ww of hole in the reel disc.
:
ttp
h
PASTE THIS SHEET ON DOOR OF MACHINE.
side to see if coins are standing on end instead of laying flat. Make
© The International Arcade Museum
25
http://www.arcade-museum.com/